Cleaning Requirements for High-Pressure Reactors

  High-pressure reactor Cleaning requirements:

1. After removing most of the residues, introduce the reaction solvent into the reactor through the vent valve, fill the reactor halfway with water, and stir for about ten minutes. Only then can you open the reactor lid and proceed to clean the inner walls of the reactor.

2 Cleaning High-pressure reactor At this time, you must open the sampling valve and clean the reactor lid, and while there is still water inside the reactor, briefly purge it with nitrogen.

3 Temporarily or infrequently used High-pressure reactor The best method for preservation and maintenance is to immerse the reactor with 70 percent by volume of clean, anhydrous ethanol; you can leave the screws loose. High-pressure reactor Only after cleaning can it be used next time.