Introduction to Hydrogenation Reactors

In the laboratory, Hydrogenation Reactor It is a commonly used device for enterprises to analyze various chemical substances. It operates smoothly, is easy to use, and produces no noise. Now, let’s talk about it... Hydrogenation Reactor A few points to note during installation.

1. Installation Location: The equipment should be installed in a high-voltage operating room that meets explosion-proof requirements. When multiple reaction vessels are installed, they should be placed separately, with each pair of reactors physically separated by a safe, explosion-proof wall. Each operating room must have an outdoor passageway and an exit. When explosive media are present, the equipment must be well-ventilated.

2. After opening the package, check whether the equipment is damaged. Install the equipment according to the structural diagram, based on the equipment model. Check the packing list to ensure that no spare parts are missing.

3. Cleaning Hydrogenation Reactor After each operation, clean the autoclave body and sealing surfaces with a cleaning solution. Clean regularly to keep them tidy. Do not use hard materials or rough surfaces for cleaning.

4. Hydrogenation Reactor Installation and Sealing of the Reactor Body and Reactor Lid The vessel body and lid are sealed with stainless steel spiral wound gaskets. Tighten the main nut evenly and symmetrically to ensure tight contact between the two components, thereby achieving a reliable seal. When tightening the nut, make sure it is tightened uniformly and symmetrically; otherwise, the lid may tilt to one side, compromising the sealing performance.

5. The feed tank and condenser can be used in a vacuum environment. When pressure builds up during the reaction process, the needle valves connected to the feed tank and condensation system should be closed to prevent damage to the glass level gauge, feed tank, and condenser due to excessive operating pressure, thereby avoiding serious hazards.

6. Installation of valves, fittings, safety valves, and temperature-sensing protection tubes: Tighten the connections to achieve a sealing effect; the arc-shaped sealing surfaces at both ends of the fittings must not be allowed to rotate relative to each other. All threaded connectors should be assembled using graphite mixed with lubricating oil or grease to prevent them from becoming loose again.

In addition, Hydrogenation Reactor After the equipment is installed, input a certain amount of nitrogen pressure. Wait 30 minutes to check for leaks. If a leak is detected, use soap bubbles to pinpoint the leak location. After identifying and sealing the leak, reapply nitrogen pressure testing to ensure there are no further leaks before starting normal operation. Before starting the laboratory reactor, place a water jacket cooling system between the magnetic stirrer and the reactor lid, ensuring that the water temperature remains below 35 degrees Celsius to prevent the removal of highly magnetic substances.

Weihai Automatic Control Reactor Co., Ltd. is a manufacturer. Magnetic Stirred Reactor 、 Hydrogenation Reactor 、 Laboratory Reactor 、 Stainless Steel Reactor of the Reaction vessel Manufacturers, you're welcome to come and discuss cooperation!